• Sign Up! To view all forums and unlock additional cool features

    Welcome to the #1 Fiesta ST Forum and Fiesta ST community dedicated to Fiesta ST owners and enthusiasts. Register for an account, it's free and it's easy, so don't hesitate to join the Fiesta ST Forum today!


Door handle replacement or just paint?

Messages
74
Likes
13
Location
SoCal
#1
A piece of wood flew and hit my roof rack and the side of the door. Luckily, only the handle is damaged. It seems like it just scrape the paint off. Get a new door replacement (comes painted) or take it to the body shop to paint? ImageUploadedByTapatalk1455770329.123799.jpg
 


Messages
128
Likes
42
Location
Noneya
#2
Is it just the top surface of the paint, or is it gouged into the plastic? Might end up cheaper to replace the handle if it's more than just the surface.
 


MKVIIST

5000 Post Club
Staff Member
Premium Account
Messages
5,772
Likes
1,035
#3
Looks like you can probably sand that down and paint it yourself.
 


Chuckable

Active member
Messages
559
Likes
90
Location
South Florida
#4
Looks like the paint is gouged from the picture. Why not try to sand and paint it on your own for a few bucks (like MKVIIST said), and if you don't like the results then just buy a new pre-painted handle?
 


OP
T
Messages
74
Likes
13
Location
SoCal
Thread Starter #7
Thanks everybody. The handle is fine, just the paint. I will look into getting some touch up paint. Btw, anybody know how to remove the door handle to make the painting process easier?
 


Messages
128
Likes
42
Location
Noneya
#8
Thanks everybody. The handle is fine, just the paint. I will look into getting some touch up paint. Btw, anybody know how to remove the door handle to make the painting process easier?
I've never removed the handle on a Fiesta, but have removed plenty of others in my time. It's usually not that hard, but can be a pain depending on how tight it is and the clip scenario. In my experience you have remove the door trim and then reach inside to unclip the rods that actually open the door when you pull the handle. There should be a couple nuts attaching the handle assembly to the door and once you've taken them out and unclipped any rods it should pop out. Be careful though because there might be additional retention clips keeping the handle in place and you don't want to break them.
 


Messages
435
Likes
108
Location
Campbell
#9
If you go to the trouble of removing the handle, look at the time you save and the risk of a bad touch up you avoid if you can get a factory painted new or used part.

At least look at the cost of new vs the cost of touch up paint.
 




Top