I did a ton of research on doing LEDs in the indicators but I haven't come across the issue I'm having. I put in LEDs at all 4 corners and wired a 50w 3ohm load resistor in each taillight. It's my understanding that the left and right sides are on the same circuit, so instead of a 50w 6ohm load resistor at each bulb, I only need the single load resistor at a lower ohm. I used a multimeter to figure out which wire was the positive and which was ground (orange +, black -).
When the parking/headlights are off, the LEDs flash normal. When the parking/headlights are on, the LEDs hyperflash. I've tried every combination of wires and a few different resistors and the same result.
Has anyone else experienced this issue and if so, what was the solution?
When the parking/headlights are off, the LEDs flash normal. When the parking/headlights are on, the LEDs hyperflash. I've tried every combination of wires and a few different resistors and the same result.
Has anyone else experienced this issue and if so, what was the solution?