Hey all. I wanted to put some photos and information about my build up. Long story short, I had a BRZ in the same basic white pearl color that had the dreaded P0014 failure - basically the cam gears or something having to do with that were manufactured out of spec and it would stall in idle and some other fun stuff. In addition to the trunk leaks, HPFP chirp, and other issues I got tired of it and traded it in for a 6MT Challenger R/T.
Fast forward a couple of years. Lacking a small go-cart type car for back road enjoyment, which the R/T is certainly not, I wanted something tossable and fuel efficient. Wife said no to the Miata and encouraged me to get another WRX. Having lemon-lawed my last brand new, leaky WRX, I opted to avoid the Subaru brand and looked at the Fiesta and Focus ST and Focus RS. The RS being too expensive and brand new, and the memory of the defective BRZ still fresh in my mind, I opted on buying this brand new 2016 Fiesta ST, fully loaded, with about 20 mi on the Odometer.
Here is what is on it right now:
Engine/Power:
1. Mountune induction kit
2. Cobb (Green) Filter
3. Depo Intercooler
4. Mishimoto OCC
5. CFM Performance Intake Symposer Delete w/ Boost port
6. Depo Catted Downpipe
7. CPE Catback Exhaust w/ Satin Tips
8. Depo Intercooler Charge Piping & T-Bolt Clamps all around
9. Velossa Tech Big Mouth Ram Air duct - Black W/ White trim
10. (Need to Install) GFB DV+
11. Mountune FL-400S Oil Filter & Mobil1 Full Synthetic 5w20
Suspension/Drivetrain:
1. (Pending - Need to Install) Mountune quick shift kit
2. Cobb Rear Motor Mount
3. (Pending - Need to Install) Boosted Designs transmission cable bracket bushings
4. (Pending - On the Way) Pierce Motorsports Stage 1 Street Kit - Front Strut Tower Bar, Rear Torsion Beam & 2 Point Lower Front Brace
5. Torque Solutions Exhaust Bushings
6. (Pending - Need to Install - Replacing Cobb) CPE Rear Motor Mount
Interior/Dress-Up/Misc:
1. No Pistons gas pedal spacer
2. Boosted Designs dead pedal & battery tie-down ("ST")
3. WC Lathwerks Hybrid Piston shift knob in black copolymer and satin finish w/ 6MT and ST engraving & knurling
4. (Pending - Need to Install) Redlineauto custom Leather Shift Boot (white stitching) and armrest cover
5. Spare tire & gear removal
Exterior:
1. UK Spec Projector Headlights
2. Perrin 2 in. Shorty Antenna
Tuning:
1. Cobb AccessPort Base Stage 3 (For now)
2. (Pending - Wishlist) Tune+ Custom Tune or DHM tune.
I'm just about done unless I decide to go C39 or X47. Or DHM quick spool.
I will be updating this over time. Sorry for the lack of photos but I'm in a bit of a rush.
Best,
2Hemis
Fast forward a couple of years. Lacking a small go-cart type car for back road enjoyment, which the R/T is certainly not, I wanted something tossable and fuel efficient. Wife said no to the Miata and encouraged me to get another WRX. Having lemon-lawed my last brand new, leaky WRX, I opted to avoid the Subaru brand and looked at the Fiesta and Focus ST and Focus RS. The RS being too expensive and brand new, and the memory of the defective BRZ still fresh in my mind, I opted on buying this brand new 2016 Fiesta ST, fully loaded, with about 20 mi on the Odometer.
Here is what is on it right now:
Engine/Power:
1. Mountune induction kit
2. Cobb (Green) Filter
3. Depo Intercooler
4. Mishimoto OCC
5. CFM Performance Intake Symposer Delete w/ Boost port
6. Depo Catted Downpipe
7. CPE Catback Exhaust w/ Satin Tips
8. Depo Intercooler Charge Piping & T-Bolt Clamps all around
9. Velossa Tech Big Mouth Ram Air duct - Black W/ White trim
10. (Need to Install) GFB DV+
11. Mountune FL-400S Oil Filter & Mobil1 Full Synthetic 5w20
Suspension/Drivetrain:
1. (Pending - Need to Install) Mountune quick shift kit
2. Cobb Rear Motor Mount
3. (Pending - Need to Install) Boosted Designs transmission cable bracket bushings
4. (Pending - On the Way) Pierce Motorsports Stage 1 Street Kit - Front Strut Tower Bar, Rear Torsion Beam & 2 Point Lower Front Brace
5. Torque Solutions Exhaust Bushings
6. (Pending - Need to Install - Replacing Cobb) CPE Rear Motor Mount
Interior/Dress-Up/Misc:
1. No Pistons gas pedal spacer
2. Boosted Designs dead pedal & battery tie-down ("ST")
3. WC Lathwerks Hybrid Piston shift knob in black copolymer and satin finish w/ 6MT and ST engraving & knurling
4. (Pending - Need to Install) Redlineauto custom Leather Shift Boot (white stitching) and armrest cover
5. Spare tire & gear removal
Exterior:
1. UK Spec Projector Headlights
2. Perrin 2 in. Shorty Antenna
Tuning:
1. Cobb AccessPort Base Stage 3 (For now)
2. (Pending - Wishlist) Tune+ Custom Tune or DHM tune.
I'm just about done unless I decide to go C39 or X47. Or DHM quick spool.
I will be updating this over time. Sorry for the lack of photos but I'm in a bit of a rush.
Best,
2Hemis