• Sign Up! To view all forums and unlock additional cool features

    Welcome to the #1 Fiesta ST Forum and Fiesta ST community dedicated to Fiesta ST owners and enthusiasts. Register for an account, it's free and it's easy, so don't hesitate to join the Fiesta ST Forum today!


Adapters to convert to 4 x 100 bolt pattern

Messages
56
Likes
19
Location
West Barnstable
#1
I know you can drill the rotors to convert to 4 x 100 pattern but was wondering if you could do this with adapters and run Enkei RPF1 16x8 4x100 wheels. Having the adapters would make it easier to revert back to say, use current winter wheel/tire combination. I have seen adapters available https://www.uswheeladapters.com/shop/1-4x4-25-4x100-wheel-adapter/
 


Dpro

6000 Post Club
Messages
6,188
Likes
5,828
Location
Los Feliz (In the City of Angels)
#2
People have used the adapters like the one you linked too and you can. Problemis you add a spacer and a pretty thick one at thaf. Which is why people go for the Hub redrill.
 


OP
J
Messages
56
Likes
19
Location
West Barnstable
Thread Starter #3
I was wondering about this. It might work if it was about 15mm but I think most are much thicker than that.
 


jeffreylyon

1000 Post Club
Premium Account
Messages
1,320
Likes
1,115
Location
Pittsburgh
#4
There a set of 25mm spacer/adaptors on the classified forum now. I drilled my hubs. Not too hard, *much* lighter and I don't have to worry about the clearance issues 25mm less ET is gonna cause.
 


Similar threads



Top