Hard going into 1st and 2nd after clutch and slave replacement

ShaunPanday

ShaunPanday

Member
#1
Member ID
#5830
Messages
106
Likes
15
#1
Hi Team :)
I had an issue with my clutch slave and had it replaced, did the clutch oil and axel seals at the same time. Ford used 75 FE oil which i replace with 2l Ravenol. When going into 1st or 2nd it is scratchy. any guidance what i can check.

Thank you
 


R

rgriffin97

New Member
#3
Member ID
#34173
Messages
1
Likes
0
#3
Did you get anywhere with this? I have this same issue at the moment
 


You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
LostInTransit WARNING: Focus MK4 Owners Beware of the Hardrace Rear Camber Plates Off Topic Discussions 11
Darthvader-st First gear is hard to find new trans installed professionally Transmission & Drivetrain 0
unspankable P0236 having a hard time. Please help Maintenance, Warranty Issues & Troubleshooting 0
V Hi there "Die Hards" Netherlands here (-; New Member Introduction 2
A Turbo/DP/Manifold Locking Hardware Upgrade Options Maintenance, Warranty Issues & Troubleshooting 1
Fiestastix Do I need to warm up my brakes/rotors before sending hard ? Suspension, Brakes & Chassis 4
D In idle it shakes so hard my teeth hurt. Maintenance, Warranty Issues & Troubleshooting 5
F Are Camber Bolts This Hard to Install? Suspension, Brakes & Chassis 5
G Step colders, E30 Hard Start Fiesta ST Discussions 10
A Hard to change gear under load Transmission & Drivetrain 1

Similar threads

Ford Community Posts



Top