Hello and a question :)

T

The Average Marine

New Member
#1
Member ID
#35791
Messages
1
Likes
0
#1
Hello everyone. I've had my 16' ST about 2 weeks now. The evap purge valve failed almost immediately. I have e replaced it with the 14' retrofit harness from whoosh motorsports. I still have the factory i take tho and now I have an inlet on the intake tube with nothing to go to it. Do I simply cap it off for now? I intend on getting an i take upgrade soon. Thanks!
 


isis

isis

Member
#2
Member ID
#30475
Messages
162
Likes
104
#2
Yeah just cap it off. Make sure it’s tight and not leaking.
 


You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
A Hello folks - mk6 owner New Member Introduction 4
K Hello there I need help General Automotive Discussions 2
G Hello from Bulgaria - MK7.5 ST New Member Introduction 7
S Hello from Southern Indiana and nice twisty roads! New Member Introduction 1
sleepbattery Hello new world New Member Introduction 9
luckroy Hello from SE Ohio New Member Introduction 5
CAL Hello from NW Indiana! New Member Introduction 4
A Hello from McKinney TX New Member Introduction 12
A Hello and Questions New Member Introduction 20
P Hello....and a few questions.... New Member Introduction 13

Similar threads

Ford Community Posts



Top