I'm selling my used 2j intake. I only removed it because I needed a true 3 inch intake for my DHM 360R turbo kit.
it has a small dent that is pictured and is wrapped in dei heat reflective tape. (For the most part it could use a second go round of tape)The filter has been crushed a bit, and needs to be cleaned and I will include the k&n rain sock I was running on the filter (It's somewhat damaged but still works)
I'm also going to include a mustang lower shift boot I was running on the intake to help isolate the cowl area from heat/heatsoak.
I want $80 shipped for it.
The dent in question
Note to the potential buyer: You will need to supply your own pcv hose to connect the intake to the valve cover of your car and purchase a maf extension harness or extend your own to make this intake work.
Sent from my SM-N920P using Tapatalk
it has a small dent that is pictured and is wrapped in dei heat reflective tape. (For the most part it could use a second go round of tape)The filter has been crushed a bit, and needs to be cleaned and I will include the k&n rain sock I was running on the filter (It's somewhat damaged but still works)
I'm also going to include a mustang lower shift boot I was running on the intake to help isolate the cowl area from heat/heatsoak.
I want $80 shipped for it.
The dent in question
Note to the potential buyer: You will need to supply your own pcv hose to connect the intake to the valve cover of your car and purchase a maf extension harness or extend your own to make this intake work.
Sent from my SM-N920P using Tapatalk
