Wanted: Design/Dimensions of a Fiesta ST MK7 Intake Heat Shield

Z

zanderst

New Member
#1
Member ID
#19669
Messages
1
Likes
0
#1
Hi Everyone, I am looking for the measurements/designs of an intake Heat Shield for the ST180. I want to make my own one with a cold air hose in the bottom(similar to the hose from a ST200 box).
Also, where is the best place to attach the cold air hose in the bottom for the best cold air?

Thank You
 


You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
T Electronic turbosmart plumb back bov making unwanted noise. Performance Tuning 0
SpeedandPower Help wanted. Experienced good mechanic in the Riverside, CA area? Fiesta ST Discussions 0
F WTB Wanted: Door lock bezel for uk drivers side 2015 (keyless entry) in molten orange Want To Buy 0
Woods247 WTB Team Dynamics 1.2 17x8 et35 wanted Want To Buy 4
Woods247 FND Stock Fiesta ST Grill Wanted Want To Buy 0
O WTB Wanted ST on West Coast: edit. Bought one! Want To Buy 0
Woods247 WTB Verus rear diffuser wanted Want To Buy 5
pkelly Just wanted to stop by and say hello... New Member Introduction 6
koozy Wanted: Unwanted Parts you don’t want (SoCal) SoCal Fiesta ST Owners 6
Baddie WTB Silicone radiatior hoses wanted (So Cal) Want To Buy 2

Similar threads

Ford Community Posts



Top