Latest Activity
-
Got the new Amazon fog lights as well as another set mounted behind the grille. Yellow rings come on with the headlights, and the bright... -
fST replied to the thread Official Fiesta ST Dyno Thread.good tires in 225+ wide, LSD, bracing, lower tire pressure, maybe some other things, all help. There are people with higher HP than me... -
Intuit replied to the thread Vibration from stationary.Check the passenger side engine mount. I had a clack noise on clutch release that was resolved by its replacement. I only noticed it... -
On FSWerks dyno mine registered 197whp and 271wtq, not bad going considering no tuning parts have been added but for the AP! I'm more... -
dhminer liked Dialcaliper's post in the thread Gauging interest in a run of budget big brake kit brackets?.These turned out stunningly well. Helicoils installed, packed up and dropped at the post office this afternoon
-
dhminer liked MrMann's post in the thread Gauging interest in a run of budget big brake kit brackets?.Arrived and have great instructions. got all the parts together. pity it scheduled to friggin snow this weekend.
-
custom500 replied to the thread Temp guage-.Ok- thanks. Well, at least I know ow what the ambient temp is... twice! -
SThese fellas have been useful - https://www.bluespringsfordparts.com/v-2015-ford-fiesta--st--1-6l-l4-gas?cat=body
-
SSam4 replied to the thread Bilstein B8 and other hardware needed..These fellas have been useful - https://www.bluespringsfordparts.com/v-2015-ford-fiesta--st--1-6l-l4-gas?cat=body
-
SSam4 replied to the thread What did you do to your Fiesta ST today ?.Like a job for Gillette Mach 3!
-
fST replied to the thread Official Fiesta ST Dyno Thread.There are a lot of people on the FB groups that have big turbos and well over 400hp and have been there for a while. It's my...
-
My '17 displays the outside temperature in 2 places- one at the top of the touch screen, and also on the small display right above the...
-
A lot of what SteveS stated was included in Break-in 101 written by pelotonracer2 over ten years ago. I pretty much followed his advice...
-
Silfister replied to the thread Breaking in my engine.A lot of what SteveS stated was included in Break-in 101 written by pelotonracer2 over ten years ago. I pretty much followed his advice... -
SSteveS replied to the thread Breaking in my engine.All engines should be broken in the same way. Initial start and run with gentle throttle for a short drive. Shut down, allow to cool...
-
dhminer replied to the thread Can’t insert photos in post.Makes sense, thank you sir
-
If it's not embedding then it means the image is too large. Try deleting it and uploading a cropped version of that image.
-
Mmadhatter replied to the thread Vibration from stationary.turn hard in both directions at parking lot speeds, slowly adding throttle. do you hear clicking then?
-
Rrallytaff replied to the thread Official Fiesta ST Dyno Thread.On FSWerks dyno mine registered 197whp and 271wtq, not bad going considering no tuning parts have been added but for the AP! I'm more...
-
Hey mods, any thoughts here? When making a post, I can attach the photo but no longer have the option to embed thumbnail or full image...
-
dhminer replied to the thread Gauging interest in a run of budget big brake kit brackets?.Received with thanks. Brackets are solid. Calipers just got done, ready to get them mounted.
-
-
Just got these delivered from SVTdesignFab. Sand it and throw some paint and it should be good 👍🏻
-
MMrMann replied to the thread Gauging interest in a run of budget big brake kit brackets?.Arrived and have great instructions. got all the parts together. pity it scheduled to friggin snow this weekend.
-
🐺🚂 -
SStevieST95 posted the thread Bilstein B8 and other hardware needed. in Suspension, Brakes & Chassis.Hello, I just had a general question if anybody has ran into a similar situation. I have a 2015 ST and it has a cheap set of coilovers...
