Latest Activity
-
No way, I am not wading into giving my opinion on this subject anymore. There are way smarter people here and my experience is no match... -
SSnrub replied to the thread At a crossroads with my FiST.That feels a bit expensive. The module itself is $600 new or $100 used. While I've never replaced one, I struggle to understand how...
-
SSTHeart replied to the thread ST and a model.AI is fun!
-
Sinteresting how the car changes how many doors it has...
-
INo. The garnish on the sides of the windshields is easy to remove if you understand how it's attached. There's another plastic piece...
-
Rrallytaff replied to the thread What did you do to your Fiesta ST today ?.I know of one that's going. A 2016 with 28,000 miles and the engine has NOT been touched. PM me.
-
LSPI is a common thing with ecoboost motors. Don't spend time below 2k. If the motor is cold, keep it below 3700 until there is a dot or... -
hit up crutchfield. they have adapter harnesses for just about anything you can think of. Hit up their tech support and ask questions...
-
Mmadhatter replied to the thread No-splice LOC options for Sync3?.hit up crutchfield. they have adapter harnesses for just about anything you can think of. Hit up their tech support and ask questions...
-
Mmadhatter replied to the thread Lugging and Shift points.LSPI is a common thing with ecoboost motors. Don't spend time below 2k. If the motor is cold, keep it below 3700 until there is a dot or...
-
I never go below 2k, that is the low point to shift to a different gear. if any load at all if needed, sift to a gear where I am over...
-
Don't lug it. Let it rev freely. But don't run it hard until the oil gets up to temperature.
-
interesting how the car changes how many doors it has... -
-
Capri to ST replied to the thread Lugging and Shift points.I would take the revs higher in each gear and cruise at a higher RPM, I do think you're lugging it or at least coming close. I would not...
-
SSTHeart replied to the thread ST and a model.
-
-
SThat green is a nice color
-
pixelzombie posted the thread I tried one of those hand held leaf blowers in Wash, Wax, Detailing & Paint Maintenance.I've seen the ad on IG where they dry a car but they wanted $160. I found one on Amazon for $60. It'll move large pools of water but... -
SFinishing up tuning for E50. VDyno of the last revision before I go to the hub dyno either later this week or early next week. Car is an...
-
It's actually a pretty big difference, Europe uses a MAF based tuning system instead of the American MAP style tuning we have...
-
SSTHeart replied to the thread ST and a model.
-
-
SSTHeart replied to the thread ST and a model.
-
-
Rrallytaff replied to the thread End all be all actuator replacement thread (clicking sound, part numbers, video install).My car is coming up for its 12th birthday in Sep. I've only had to replace mine ONCE and that was under warranty!
-
Intuit replied to the thread End all be all actuator replacement thread (clicking sound, part numbers, video install).About fifteen minutes after ignition off, you'll hear the HVAC system set your blend door(s). Bottom line, I don't think it will make a...
