2016 Time Attack/TT Fiesta

[Fusion Works]

You want the spacers I made for my OEM shifter? I spaced it up off the floor 1.5in. Made the car more pleasant to drive. I don't think anyone else is interested in them.

 

[EscortSportage]

You want the spacers I made for my OEM shifter? I spaced it up off the floor 1.5in. Made the car more pleasant to drive. I don't think anyone else is interested in them.
View attachment 68510

Hell yea

 

[EscortSportage]

Alright so a Nov 2025 update:

So far I installed the following:

Swave front and rear strut braces
Whoosh hot and cold side charge pipes
Afe dry mesh air filter
Whoosh silicon intake tube
Whoosh crossover pipe
Whoosh shifter bushings both ends
Whoosh short throw shifter block
Sparco rear tow strap
TB torsion beam bar

And i flushed the brake fluid with Motul 600

I have a ton of other parts coming in and more in my liviing room, im waiting to get on my friends lift to knock it all out.

 

[Fusion Works]

What is your home track or tracks?

 

[EscortSportage]

What is your home track or tracks?

LIme Rock Park is the closest to me, but I really like NJMP. Ive been up and down the east coast with the foxbody I used to track.

 

[M-Sport fan]

I'm guessing you are in the general Hillsdale/far eastern upstate area?

 

[EscortSportage]

I'm guessing you are in the general Hillsdale/far eastern upstate area?

I live in NY.

 

[EscortSportage]

Ive made a thread in the build log section, figured it would be more applicable and itll keep me organized.

 

[GGracing]

Does anyone have a decent Forscan Spreadsheet ?

 

[GGracing]

Sorry I should add for a Mk7 St180

 

[Fusion Works]

I don't know that the US Fiesta spec applies to the UK cars. Ya'll got a lot more options and such compared to us.

 

[GGracing]

Can streams will still be the same for the functions that are there.

 

[Dusterbd13]

You want the spacers I made for my OEM shifter? I spaced it up off the floor 1.5in. Made the car more pleasant to drive. I don't think anyone else is interested in them.
View attachment 68510

Got a how to, or post about these? Id love a little taller shifter in my car. Instead of rolling my own from scratch, I'd rather copy yours!

 

[Fusion Works]

Got a Lathe? These were 1,5-1.625 tall hex with a hole in each end. Both threaded. You can't go much higher without getting into the console.

 

[Dusterbd13]

Got a Lathe? These were 1,5-1.625 tall hex with a hole in each end. Both threaded. You can't go much higher without getting into the console.
View attachment 68795

Actually yes I do! I can take care of that! Thanks

 

[Fusion Works]

Actually yes I do! I can take care of that! Thanks

My brother. HAHA. Get some 6061 hex, cuz its easier than machining your own hex. .750 or 1.00 is fine. Tap both ends for M6x1.00 The chassis side will thread onto the OEM studs on the tunnel and you need to turn a small shoulder to fit inside the shifter base. You are doing away with the rubber shifter bushings. Then use some M6 bolts and washers to hold it all down. Mine are 1.650 tall tunnel to the base of the shifter. I am too lazy to pull a bolt to see what I did on the "bushing elimination" shoulder, but you can figure it out. You could probably 3D print these as well.