CPE intake (minus crossover) and Mountune symposer delete

Trader history for DangerMouse (3)

DangerMouse

Senior Member
Member ID
#6024
Messages
813
Likes
335
#1
Mountune sound symposer delete, mtc silicone hose w/ mountune clamps
$25 shipped

SOLD. CPE intake. Far from perfect but maybe you could use it.
$140 shipped

-No crossover pipe
-No clamps except tbolt for the bottom air feed tube and filter
-Lid is scratched
-No clips for the hood prop
-Filter is dirty
-Middle pipe has some rub marks
-No screws for lid. They rusted and seized after one winter. Had to cut them and remove the nuts from inside of the box. I used push pins after that. They fit and work nicely but hard to remove without a tool.

Pics are here:

https://imgur.com/a/FXMSl9y
 


Last edited:

XanRules

Active member
Member ID
#8027
Messages
652
Likes
307
#2
Great price for someone who's handy. Pop a new crossover on, wash the filter, and you've got a hell of a setup for cheap.
 


OP
DangerMouse

DangerMouse

Senior Member
Member ID
#6024
Messages
813
Likes
335
Thread Starter #4
Would the intake fit on a ramair crossover pipe?
I can't say for sure unfortunately.

I did connect a MAP intake to the Cpe crossover so chances are yes it will work. You will need a 2.75" to 3" coupler to connect the two. The cpe intake bends at the end of the crossover and the start of the middle pipe. And uses a short 45 (I think, could be less) coupler. I would get a squirrelly 45 degree coupler from MAP and see if that works. Otherwise you could always cut the cpe middle pipe straight and use a longer leg coupler.

Sorry I can't say for sure.

You could always try cpe and see if they will sell the crossover separate, that might be your best bet.
 


XanRules

Active member
Member ID
#8027
Messages
652
Likes
307
#5
In looking at my RamAir crossover and the photos of CPE bits, I think it would - you MIGHT need a different silicone coupler but that would be the only issue.
 


OP
DangerMouse

DangerMouse

Senior Member
Member ID
#6024
Messages
813
Likes
335
Thread Starter #6
In looking at my RamAir crossover and the photos of CPE bits, I think it would - you MIGHT need a different silicone coupler but that would be the only issue.
Definitely need a different coupler. It will fit, just how hard it is I don't know. I don't want to mislead people.
 


OP
DangerMouse

DangerMouse

Senior Member
Member ID
#6024
Messages
813
Likes
335
Thread Starter #7
Cpe intake sold
 


OP
DangerMouse

DangerMouse

Senior Member
Member ID
#6024
Messages
813
Likes
335
Thread Starter #8
Mountune symposer delete still available.
 


Similar threads



Top