Mountune AccessPort data logging

[Flying Fajita]

Hey all, I recently bought the Cobb AccessPort from Mountune and I am clicking the settings to set up the data logging as the instructions say. But I always get the "Too many ECU settings selected" message. I emailed the folks at Mountune and was told that it will work with the instructed settings - but it doesn't. I have become beyond frustrated with this expensive, supposed "plug and play" device. Below are the parameters sent to me and if I select all of them I get the attached error message on the accessport. Any advice, help, suggestions would be appreciated.

Thanks

 

[Cartman]

I did this last year and made a check mark next to each parameter as I switched them to prep for data logging when I first got the AP. This helped ensure the correct ones were selected.