Arlisscm's Angry Roller Skate

[arlisscm]

I wonder what the bolt pattern is on your rotor and hats? Think your pic shows a 203.2mm.
http://www.reyland.co.uk/fiesta/

I dug around a little on Paragon's website and it would appear 203.2mm is correct.

I'll confirm with a set of calipers next time I have a wheel off, likely in a week or so.

 

[Fusion Works]

Thanks. I am thinking mine are 190PCD, but have yet to confirm that. May be easier to have Coleman Racing make some up.

 

[arlisscm]

Found this.

 

[Fusion Works]

Do they happen to have a drawing of their hat?

 

[Fusion Works]

https://paragonbrakes.com/rotor-rings-330x28mm-pcd-203-2mm/

This crosses to the AP Racing part number Reyland said came with my kit. I think this is the same as the one your posted.

 

[arlisscm]

https://paragonbrakes.com/rotor-rings-330x28mm-pcd-203-2mm/

This crosses to the AP Racing part number Reyland said came with my kit. I think this is the same as the one your posted.

That's the one. Same spot I got the drawing.

I reached out to them about a hat drawing, they said they'll get back to me tomorrow. We will see what they say.

 

[Fusion Works]

Thanks. Pretty sure those are the right rotors for me. The measurements I got off the "kit" I have here were a little different than those, but Based on what Reyland just said was their part number, I think Paragon has me covered.

 

[arlisscm]

Got a diagram with some basic dimensions from Alcon for the hat. Some dimensions aren't shown, but appears to be to scale, so one could find them get them if inclined to do so...

 

[Fusion Works]

Thats hilarious. That looks like the same hat my Ryland AP Racing kit uses.

 

[arlisscm]

Thats hilarious. That looks like the same hat my Ryland AP Racing kit uses.

I wouldn't be surprised if it's a little badge engineering and/or different branding in different regions.

Either way, parts are really good, so tip of the cap to whomever actually makes them.

 

[Fusion Works]

Do you calipers have dust boots? (its far from critical)

 

[Fusion Works]

Mine has BE186NJ1018 scribed on the inside of the bell. Its done by a hand engraver so probably only means something to the original builders.