Auto Window issues

Hypergram

1000 Post Club
Member ID
#11246
Messages
1,329
Likes
902
#1
Disconnected the battery yesterday to install my quickshift, and now my driver's side window won't Auto roll up when I pull it for a second, but it works when going down. Any ideas?
 


kivnul

1000 Post Club
Member ID
#3947
Messages
1,207
Likes
732
#2
Now it works just like my '16!. Try disconnect / reconnect the battery again?
 


Member ID
#12178
Messages
68
Likes
38
#3
You should confirm both positions using the button.
 


OP
Hypergram

Hypergram

1000 Post Club
Member ID
#11246
Messages
1,329
Likes
902
Thread Starter #4
fixed it with an ignition cycle. Thanks guys.
 


Remi

Member
Member ID
#11349
Messages
224
Likes
226
#7
Roll the window all the way up and keep pulling up on the switch for a second and it will reset
Sweet, this just worked for me.
I don't know why the auto up feature stopped working out of the blue. I haven't disconnected the battery lately. Oh well, at least it works again. Thanks for the info!
 


Member ID
#4827
Messages
405
Likes
408
#8
I just had to replace my dead battery and of course lost auto-up/down function. I remembered reading you had to reset the switch by holding up/down for a bit each way. I only have been able to reset the auto-down function though. Any suggestions?

Update: Tried again today. Rolled all the way up, released, then held up again, heard a click, and now auto up is working again.
 


Last edited:

green_henry

1000 Post Club
Member ID
#7801
Messages
1,049
Likes
786
#9
I just had to replace my dead battery and of course lost auto-up/down function. I remembered reading you had to reset the switch by holding up/down for a bit each way. I only have been able to reset the auto-down function though. Any suggestions?

Update: Tried again today. Rolled all the way up, released, then held up again, heard a click, and now auto up is working again.
I had exactly the same experience yesterday (original battery on my '17 finally died). The key is to release; missed that on the first atttempt, re-read your post, and voila! Thanks
 




Top