I tried to upgrade to SS lines this weekend and followed the instructions pretty well I think and topped off the fluid after each wheel then I went through and bled them as suggested by others on the forum, but when the car is on the brakes wont release. I have reset the calipers twice and they seem fine, they slide and compress still and they release from the rotor when I open the nipple so I put the old hoses back on and re bled it again but no luck they still wont release under vacuum. Could I still have that much air in the system or did I break something the pedal is still firm and the brakes still have pressure, looks normal when I bleed they just wont release does anyone have any insights on this?