Car dying on warm start

[Andrew_FiST]

Hey guys, I have a 2016 FiST I've been trying to fix for the last few months. It's doing this thing where basically it cold starts fine, gets to operating temp, drives fine and then if I shut it off and don't let all the temps go cold, when I start it again it will get like 30-40 feet and just like cut power. No matter how much throttle or gear I put it in the revs will fall and if I put it in neutral it will idle at like 500 RPMs until I shut it off and start it again. And then sometimes it will do it again and sometimes it will wait longer before it does it again. I'm not getting a CEL or any stores codes so I can't figure it out

 

[Jabbit]

Sounds like the EVAP issue that's common.

 

[TyphoonFiST]

Do you have a scantool?

 

[Andrew_FiST]

Sounds like the EVAP issue that's common.

That's what I was thinking but I haven't seen anyone with anything similar so I don't even know where to start

 

[Andrew_FiST]

Do you have a scantool?

I don't but the last time it did pop a CEL I had a P068A code for a ECM/PCM Power Relay De-Energized Performance - Too Early but I swalled the relay and it went away

 

[Bishop]

I don't but the last time it did pop a CEL I had a P068A code for a ECM/PCM Power Relay De-Energized Performance - Too Early but I swalled the relay and it went away

You replaced the relay?
Glad it's running normally now. Thanks for updating your thread.