How-To: Relearn new TPMS sensor video

OffTheWall503

1000 Post Club
Member ID
#4208
Messages
1,991
Likes
459
#1
Not my video, but I just recently installed a set of used wheels/tires from another Fiesta and needed to relearn these new TPMS sensors to my car. After a local tire shop having no luck because my car "is a 2016 model," I did some searching and found all you need is a Ford TPMS tool (TPMS-19) and the correct steps.

I purchased the tool from Amazon for $30 shipped with Prime. I initially thought the way to relearn was to do the 6-press of the hazard button method which initiated the program mode, but wouldn't take when using the tool and would time-out. Below is the proper procedure, video is for a Mustang but these steps worked perfectly on my FiST.

[video=youtube;H0x5g2pujUM]https://www.youtube.com/watch?v=H0x5g2pujUM[/video]
 


KKaWing

Active member
Member ID
#455
Messages
702
Likes
206
#2
Sometimes when the remote has a hard time picking up the sensor, I point the arrow right at the bottom of the valve stem on the tire side. Just a random tip I guess...
 


Member ID
#128
Messages
59
Likes
10
#3
Thanks! Had the exact same situation.....bought winter wheel/tire combo off this forum for my 2016 FiST. Tried hazard switch method after reading owners manual. It would go into learn mode but not recognize the reset tool. The CJ video worked perfectly!! Happy Holidays to ya!
 


OP
OffTheWall503

OffTheWall503

1000 Post Club
Member ID
#4208
Messages
1,991
Likes
459
Thread Starter #4
Yep, I ran into that same issue and this video procedure solved the problem! Glad it worked for you.
 


Similar threads



Top