Did some lighting mods today.
I got LED license plate lights, and Kensun HID kit for the fogs.
License plate lights were easy.
Take a small flat head screw driver, push the tab over and pull out, pull the bulb and put the LED bulb in and it snaps back in place. Easy.
Before
after
Fog lights were a little tougher.
Remove the two screws- front and rear of the light- there is a Phillips plastic Rivet that must be removed, I found if you slid the housing back towards the windshield the rear clip would come up then just lift and set to the side.
Reach down and turn the bulb and pull it out. Then- connect the plugs from the ballast to the lights, put the bulb in the housing in the same way it was before- direction the L connector is pointing out- then take the last plug and plug into the plug coming from the car. Easy- now to mounting, I I removed a screw, not really sure what it's for- I didn't look too far, and then out the ballast mount on and put the screw through the bracket and tightened back up.
Worked out nice, reinstall the headlights and you're on your way.
Here is the brightness difference- but then again it wasn't aligned right.
fogs only
fogs and lb