Post a picture of your Fiesta ST as it sits right now!

dyn085

dyn085

2000 Post Club
#1,043
Member ID
#1041
Messages
2,434
Likes
820
#1,043
If you're talking about the black plastic in front of the intercooler, the bumper does not need to be off.
 


dyn085

dyn085

2000 Post Club
#1,045
Member ID
#1041
Messages
2,434
Likes
820
#1,045
Just like it was stated earlier, just start at one side and pull, working your way to the other. The only difference is that you don't need to worry about the bumper being off.
 


LT Berzerker

LT Berzerker

Active member
#1,047
Member ID
#1303
Messages
668
Likes
130
#1,047
I am actually hacking my grille trim up and putting just the corner sections back in place.
 


frankiefiesta

frankiefiesta

1000 Post Club
#1,048
Member ID
#1060
Messages
1,852
Likes
509
#1,048
I pulled the black lower grill piece out (took 15 seconds you just have to yank it) then cut the vertical pieces with my dremel. Once it was smooth I applied white touch up paint. If you pull the bumper off to do that you have too much time
 


You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
R it posted now thanks New Member Introduction 0
BadShot My FirST Post (Get It?) New Member Introduction 10
Dpro Had to Post Fiesta ST Discussions 8
B Long time lurker, first time poster New Member Introduction 2
LostInTransit You Can Now Follow My Post On RMSMotoring Off Topic Discussions 7
J Posted to wrong forum. Tried to delete. New Member Introduction 1
Brandonr757 Repost: Upgrading your Sync 3 (2016+) Fiesta ST to use the 3.4.xxxx version of Sync software! Audio-Video, Electronics, Sync & MyFord Touch 32
XR650R This may have already been posted, Fiesta ST Photos & Media 4
C Post Radiator-swap A/C Failure Maintenance, Warranty Issues & Troubleshooting 4
Mike King Continuing my sedan ST build here from the new member post. I am not the first. Fiesta ST Build Projects 219

Similar threads

Ford Community Posts



Top