Up for sale is my Mishi J-line intercooler with all the accessories you need to bolt it up. This includes:
All of this together would cost you $400 new from ModBargains (and would not get you longer leg elbows). So, I’m offering this set for $300 shipped.
I ran this setup for the last month and a half over 1900 miles. The only signs of use is a bit of rust on the mounting bolts and a few scuffs and scratches on the intercooler itself (see pictures).
Full disclosure: This is not a simple plug and play kit. It does take some work to get everything to fit. For best fitment, I recommend slightly trimming the bumper cover. In the mounted picture below, you can see the small cuts I made to the bumper cover at the bottom, where it meets the end tanks.
The reason I’m selling is that no matter what you do, the bottom of the bumper cover and the bottom air deflector will hang down lower than stock. My issue is that my driveway ends at a very acute angle and the lower part of the bumper cover scrapes without fail. I haven’t had this happen in any other situations (like speed bumps). But ultimately, I have to go down my driveway at least once a day and just don’t want to mar my bumper cover any more.
Ships USPS from Maryland. Best way to reach me is via PM.
- Black J-line
- 2x 90 degree silicone elbows (these have slightly longer legs than the Mishimoto elbows, providing for better fitment)
- 2x Vibrant couplers
- 6x 3 in. Mishi T-bolt clamps
- CMBuildz Custom Bracket
All of this together would cost you $400 new from ModBargains (and would not get you longer leg elbows). So, I’m offering this set for $300 shipped.
I ran this setup for the last month and a half over 1900 miles. The only signs of use is a bit of rust on the mounting bolts and a few scuffs and scratches on the intercooler itself (see pictures).
Full disclosure: This is not a simple plug and play kit. It does take some work to get everything to fit. For best fitment, I recommend slightly trimming the bumper cover. In the mounted picture below, you can see the small cuts I made to the bumper cover at the bottom, where it meets the end tanks.
The reason I’m selling is that no matter what you do, the bottom of the bumper cover and the bottom air deflector will hang down lower than stock. My issue is that my driveway ends at a very acute angle and the lower part of the bumper cover scrapes without fail. I haven’t had this happen in any other situations (like speed bumps). But ultimately, I have to go down my driveway at least once a day and just don’t want to mar my bumper cover any more.
Ships USPS from Maryland. Best way to reach me is via PM.
