Stock exhaust tip diameter?

[DAPR]

Anyone know the OD of the pipe going to the tips? I like the factory exhaust and would like to add nicer tips.

 

[TyphoonFiST]

Only the tip?

 

[Clint Beastwood]

Only the tip?

To OP - I can try to measure mine when I get home, my stock exhaust is hanging from the ceiling in my garage.

 

[DAPR]

Can someone measure this for me. Obviously the OD size that I can have them welded to.

 

[TyphoonFiST]

Can someone measure this for me. Obviously the OD size that I can have them welded to.

I will mic. Mine tomorrow morning....is that ok...I work overnights till 6a....worked 24hrs now going back.ok?
Sent from my SM-N950U1 using Tapatalk

 

[Clint Beastwood]

I can't find my muffler, just the part from the muffler forward :facepalm: if I can find it in my garage I'll throw a caliper on it.

 

[DAPR]

I believe they are 2" both me and a guy at the local muffler place seemed to agree after I had him eyeball it. Still have not actually measured. I'm going to look for some 2" I let to 3"-3.5" outlet tips.

 

[Clint Beastwood]

The circumference is 6.5, divided by pi is 2.069” diameter (52.55mm) - couldn’t find my calipers just my fabric measuring tape

 

[green_henry]

Anyone know the OD of the pipe going to the tips? I like the factory exhaust and would like to add nicer tips.

I'm interested in replacing the tips as well. Did you find anything interesting (flowmaster? magnaflow? other?)

 

[alexrex20]

I loooooove my Milltek tip. It's amazing how big a difference just the tip makes. I went from noticeable drone (Magnaflow universal muffler with a generic dual outlet double-wall tip from the exhaust shop) to ZERO drone when i switched to the single Milltek tip.