Weird Problem

Member ID
#5807
Messages
32
Likes
2
#1
After reading around it seems the car has a weird issue with stalling after filling it up. Last night I put some gas and every stop the revs would drop really low and the car actually shut off once. I know the EVAP valve should be a fix and hopefully the dealer can fix it on the spot when I take it in monday. Does anyone know if it is safe to drive and go away as the tank gets used up? Or will it only happen at lights? Should I go back to the gas station and just reinsert the pump for a miniute?
 


neeqness

1000 Post Club
Member ID
#4689
Messages
1,398
Likes
166
#2
After reading around it seems the car has a weird issue with stalling after filling it up. Last night I put some gas and every stop the revs would drop really low and the car actually shut off once. I know the EVAP valve should be a fix and hopefully the dealer can fix it on the spot when I take it in monday. Does anyone know if it is safe to drive and go away as the tank gets used up? Or will it only happen at lights? Should I go back to the gas station and just reinsert the pump for a miniute?
There is another thread on this. One other possible cause that came up is from topping off the tank after the pump automatically cut offs. One possible solution is using the nozzle to release pressure. You could probably also release it by using the plastic funnel that came with the car for filling by can.


http://www.fiestastforum.com/forum/showthread.php?t=12023

EVAP Valve
http://www.fiestastforum.com/forum/showthread.php?t=11529
 


TyphoonFiST

9000 Post Club
Premium Account
Member ID
#3304
Messages
11,856
Likes
8,309
#3
Isn't emission stuff 7yr/70k?
 


Member ID
#2077
Messages
87
Likes
11
#4
I usually just rev it a few times and it's fine. Only happens to me when I fill it with less than an 1/8th of a tank left.

Sent from my D6503 using Tapatalk
 


1nvoke

New Member
Member ID
#5904
Messages
2
Likes
0
#5
Exact thing happened to me last week. Its completely gone away by now, but it was a bit weird.
 


Member ID
#3943
Messages
38
Likes
2
#6
Just leave the nozzle in for at least 30 seconds after you finish pumping. My 16 will almost stall and run rough for a minute if I don't.

Sent from my SM-N920V using Tapatalk
 


Member ID
#4335
Messages
91
Likes
32
#7
I've only had this happen to me once when I filled up after the low fuel light came on.

Typically I fill up before the light goes on, and I never continue filling after the pump clicks.

Sent from my SM-G920W8 using Tapatalk
 


Similar threads



Top