So long story short, I'm an idiot. I was doing a DIY install on my sub and amp, done this at least 6 times in the past. All the wires are run except for the power amp wire. I tried the method of going out the side and through the fender, but it just wasn't happening with my 0g wire. I then tried to use the grommet above the clutch pedal to push through the firewall and into the engine bay. Well, I think i pushed a little too hard and two of the wires that run along the wiring harness loom broke. I can see the wires that I need to solder back together, I just cant get enough slack to get them to a point to where I can work with them. The car powers on, but it won't start because of my dumbness. Anybody have any experience with this area or any ideas on what I could do? I've attached a picture for reference. TIA.
