PIAA Platinum H7 LED Bulb in Euro Headlamps

TDavis

1000 Post Club
Member ID
#7837
Messages
1,489
Likes
1,225
#22
Thanks! Took a lot of time deciding how to paint lol.

Last teaser before install



Sent from my SM-G935W8 using Tapatalk
Excited to see those on the car!

How easy where the euros to retrofit?
 


Member ID
#5331
Messages
108
Likes
27
#24
Alright, just got my PIAA leds installed yesterday! definitely much brighter than the halogens that originally came with the lights. It was tricky tucking the led controller box inside the assembly but with enough finesse, it went in. Also, i had to bend one of the tabs on my left light in order to keep the bulb seated. The heat sink is heavy, so if its not seated very snuggly it could cause the headlight to pop out of adjustment. I didn't have any issues with it bouncing around during my test drive yesterday and my drive in to the work today. So far so good!
 


Member ID
#4196
Messages
326
Likes
116
#25
Alright, just got my PIAA leds installed yesterday! definitely much brighter than the halogens that originally came with the lights. It was tricky tucking the led controller box inside the assembly but with enough finesse, it went in. Also, i had to bend one of the tabs on my left light in order to keep the bulb seated. The heat sink is heavy, so if its not seated very snuggly it could cause the headlight to pop out of adjustment. I didn't have any issues with it bouncing around during my test drive yesterday and my drive in to the work today. So far so good!
Any before/after pictures?
 


OP
VirtualRonin

VirtualRonin

Active member
Member ID
#1846
Messages
562
Likes
457
Thread Starter #27
Alright, just got my PIAA leds installed yesterday! definitely much brighter than the halogens that originally came with the lights. It was tricky tucking the led controller box inside the assembly but with enough finesse, it went in. Also, i had to bend one of the tabs on my left light in order to keep the bulb seated. The heat sink is heavy, so if its not seated very snuggly it could cause the headlight to pop out of adjustment. I didn't have any issues with it bouncing around during my test drive yesterday and my drive in to the work today. So far so good!
Nice! I love mine, been running them over a month now no issues. Did you end up getting the longer caps from TRS as well?


Sent from my iPhone using Tapatalk
 


Member ID
#5331
Messages
108
Likes
27
#28
Nice! I love mine, been running them over a month now no issues. Did you end up getting the longer caps from TRS as well?


Sent from my iPhone using Tapatalk
Yes i did. There's no way the bulb would fit without the extended caps. I also found out that these LEDs don't burn bright enough to melt ice/snow off of the lenses. So be mindful of that. It hurt my bulb output when i was driving in pour weather the other day.

UPDATE: Not terribly thrilled with the output in pour weather conditions. Not sure if it was just the wet roads reflecting the light yesterday, but they didn't seem too bright. I'll keep running them for a while and see if my opinion changes.
 


Last edited:
Member ID
#5331
Messages
108
Likes
27
#29
So apparently the euro lights shipped aimed too low for me. Once I adjusted them and raising up these LEDs went from alright to great!
 


Member ID
#4965
Messages
29
Likes
0
#30
Nice! I love mine, been running them over a month now no issues. Did you end up getting the longer caps from TRS as well?


Sent from my iPhone using Tapatalk
Do you know how bright the drl strip is compared to the oem ford lights drl? Have you seen both in person?
 


OP
VirtualRonin

VirtualRonin

Active member
Member ID
#1846
Messages
562
Likes
457
Thread Starter #31
Do you know how bright the drl strip is compared to the oem ford lights drl? Have you seen both in person?
I haven't seen the OEMs in person so I couldn't speak to the brightness


Sent from my iPhone using Tapatalk
 


TyphoonFiST

9000 Post Club
Premium Account
Member ID
#3304
Messages
11,828
Likes
8,292
#33
How long did it take to get the lights after you ordered them? [thankyou]
 


Member ID
#8601
Messages
167
Likes
62
#35
Any update on these? Any pictures of the output?


Sent from my iPhone using Tapatalk
 


D

Ducky

Guest
#37
Correct. I replaced the projector so it was fine, but it's something to consider if you don't want to drop $1000+ on lights.
 




Top