Can you mix motul dctf with factory motorcraft dctf

Member ID
#28384
Messages
5
Likes
0
#1
I recently put in a used trans and had to pull again due to slave cylinder failure. Lost a little fluid when pulling out axel. It has brand new motorcraft dctf from ford but I have some motul dctf laying around. Can I top off with motul or do I need to do full flush and fill?
 


Capri to ST

1000 Post Club
Member ID
#3777
Messages
1,822
Likes
2,343
#3
I probably wouldn't do it, but that's more from having a good case of car OCD than any particular knowledge that it wouldn't work. I would check and see that the Motul DCTF meets the Ford spec, if it does you'll probably be fine, if it doesn't, then that's a legitimate reason not to use it.
 


Similar threads



Top