Fiesta ST Backup Camera Intall Guide(Without Damaging your Vehicle)

[Spork1569]

I was able to do it despite not being electrically inclined at all , like atlantaM3 said there's a ton of good guides online that make it super easy to follow.

Only recommendations that helped me too is using the harness mentioned above and the Canopener tool below which basically does the for scan stuff for you if you're worried about that.

https://www.4dtech.com/ford-backup-camera-programmer-harness-for-ford-vehicles/

 

[atlantaM3]

I used the 4D stuff too, made that part plug-n-play. worth the $ for me personally.

 

[dailowill]

I also purchased the 4D harness for my install, but skipped the Canopener tool. Forscan is relatively easy to use (compared to other car programming software) and tons of guides are available.

 

[itouma99]

I also purchased the 4D harness for my install, but skipped the Canopener tool. Forscan is relatively easy to use (compared to other car programming software) and tons of guides are available.

Did you guys have to wire the red wire that comes off the RCA cable that goes into the 4D harness? This is my first time trying to install a reverse camera lol

 

[atlantaM3]

Not unless you want to do it that way. I tapped power from the reverse lights in the rear, as much closer.

 

[dailowill]

Not unless you want to do it that way. I tapped power from the reverse lights in the rear, as much closer.

This is the way