Lower Chassis/Tie Brace. A-Arm Bolt Torque?

[srirachapenguin]

I've recently acquired the Pierce Motorsports Street Suspension Package. Looking online, I've found all the information I need for the install with one exception: Does anyone know the proper torque for the a-arm bolts where the lower tie brace will mount? I've been told to torque them back to the factory specs, but I cannot seem to find those specs anywhere.

 

[Mr. Pickles]

I couldn't find anything either. I torqued mine to 125ftlbs. I went off the focus torque spec. I think they range from 125-170ftlbs.

 

[ThaiFiesta]

I've read this on the forum.
Torque :
Stage 1: 63 Nm / 46.5 ftlb
Stage 2: 180?

The 180? is 180 degrees of rotation on the bolt after it is torqued to 63Nm

I've also read 110Nm which is what I used on mine.

 

[Plainrt]

Tagging along

 

[srirachapenguin]

Thank you for the info, everyone

 

[bodytech]

I installed mine last night, couldn't find a consistent answer online so I did about 4-5 ugga duggas with an impact

 

[srirachapenguin]

Ugga duggas is a technical term, right? Haha