Stock alignment specs

Member ID
#523
Messages
261
Likes
39
#1
Does anyone have the stock alignment specs? I installed Eibach springs over the weekend and want to make sure the tire shop doesn't use base model Fiesta specs when checking the alignment.
Thanks for the info.
 


Young L

Active member
Member ID
#1346
Messages
524
Likes
88
#2
Does anyone have the stock alignment specs? I installed Eibach springs over the weekend and want to make sure the tire shop doesn't use base model Fiesta specs when checking the alignment.
Thanks for the info.
good call. ima about to do the same thing but with H&R springs
 


Member ID
#1924
Messages
59
Likes
18
#3
I can't remember the toe-in/out but camber for my driver side was -0.9 and passenger side was -1.5. Mind you this was after 15000 miles.
 


BRGT350

1000 Post Club
Member ID
#1353
Messages
1,075
Likes
763
#4
Front
-1.18 +/-1.25 camber
4.08 +/-1.00 caster
0.20 degrees +/-0.20 degrees toe split (positive toe in, measured at curb ride height, full tank of fuel)

Rear
-0.64 +/-1.25 camber
0.00 degrees +/-0.50 degrees toe split
 


D1JL

7000 Post Club
Staff Member
Premium Account
Member ID
#1011
Messages
7,840
Likes
4,080
#5
Here is the complete chart from the Service Manual.
Just in case you need more info or wish to make a comparison.

Fiesta Alignment Specs


Dave
 


OP
Tex ST-AR
Member ID
#523
Messages
261
Likes
39
Thread Starter #6
Thanks Dave, your a wealth of knowledge. Or maybe you just know how to work the internet better than me either way [twothumb]
 


Similar threads



Top