Volume knob issue

Member ID
#8949
Messages
116
Likes
69
#1
Recently my volume knob on the dash started to turn the volume up when I turn it down (turning left). It does this 10% of the time. Its really annoying when I go to turn the volume down and it goes all the way to MAX.....

Anyone else have this issue? Any fix? Steering wheel volume works fine... I suppose the volume knob on the dash isn't necessary but Id like to love the knob issue if anyone else has experienced this.

thanks in advace!
 


Capri to ST

1000 Post Club
Member ID
#3777
Messages
1,822
Likes
2,343
#2
Recently my volume knob on the dash started to turn the volume up when I turn it down (turning left). It does this 10% of the time. Its really annoying when I go to turn the volume down and it goes all the way to MAX.....

Anyone else have this issue? Any fix? Steering wheel volume works fine... I suppose the volume knob on the dash isn't necessary but Id like to love the knob issue if anyone else has experienced this.

thanks in advace!
You could try a system reset for Sync 3, if that's the system you have. You press and hold the seek up button while pressing the radio power button. It's worth a try, and doesn't lose any of your settings if I remember correctly.
1653491518283.png
 


M-Sport fan

9000 Post Club
Member ID
#4150
Messages
14,645
Likes
7,144
#3
^^^I tried multiple times to do this reset in order to get my in-screen compass to start working again.

No bueno. [:(]
 


CarGuy

1000 Post Club
Member ID
#349
Messages
1,057
Likes
661
#4
You could try a system reset for Sync 3, if that's the system you have. You press and hold the seek up button while pressing the radio power button. It's worth a try, and doesn't lose any of your settings if I remember correctly.
View attachment 48944
Or just pull the number 10 fuse for a bit. It sometimes works better than the master reset.

Sent from my SM-S908U using Tapatalk
 


Intuit

4000 Post Club
Member ID
#4881
Messages
4,055
Likes
2,582
#5
With the old knobs that were completely analog, this issue would manifest as static.

With the digitally processed knobs, it shows up as an unpredictable response to input.
The signal from the knob is so noisy, jittery, that the computer can't really tell what direction you're turn it.
My Dad's old Sony Amplifier does the same thing. The volume knob is rarely used since it's controlled via remote.
What I typically do is turn the stereo OFF, go buck wild turning the knob back and forth a several seconds.
That knocks the oxidation off and works fine for some time after turn it back on.
Of course the impact is temporary but again, rarely used.

I believe they used to use electrical contact cleaner for the old UHF/VHF analog tuner knobs.
I'd follow that up with some silicon spray. "Blaster" and "Liquid Wrench" make some good sprays.
The spray helps seal out air, making it harder for it to oxidize again.

Question that becomes clear though, what's the easiest way to get the these chemicals onto the needy bits of the potentiometer?
 




Top