What was your first Fiesta ST mod?

[Kip2MyLou]

Lamin-x

How did you put those on? Did you take the whole fog light assembly or place the film over light

 

[Original J-Pat]

Lamin-x

I need to install mine just got them yesterday looks good

 

[Original J-Pat]

How did you put those on? Did you take the whole fog light assembly or place the film over light

I believe you just put the film on the light i just got mine and thats what the instructions say

 

[Xtreme545]

How did you put those on? Did you take the whole fog light assembly or place the film over light

Just placed over, with use of a lil water and credit card

 

[Kip2MyLou]

What did you go with the tabs that are attached?

 

[Xtreme545]

What did you go with the tabs that are attached?

Pushed them back with edge of credit card, you cannot see them

 

[Kip2MyLou]

Oh okay. I'll try that tomorrow then. What did you use the water for? I'm a rookie when it comes to this stuff. Ha.

 

[Xtreme545]

Oh okay. I'll try that tomorrow then. What did you use the water for? I'm a rookie when it comes to this stuff. Ha.

Trust me spray a lil water on it, or it will stick to everything, the water allows you to maneuver it around and then just push water out with fingers, I also found that once you have them set kick your fog lights on, the heat helps smooth them out too

 

[Kip2MyLou]

Okay I'll do all that. Thanks man for the advice!

 

[AMontgomery]

Technically, my first change was debadging and removing dealer logos. But because it was so basic that's not how I voted in the poll. I have a Cobb stage 1 kit on route complete with RMM, drop in filter, and AP. I'll probably also do the airbox modification while I install everything else, and possibly the sound symposer delete as well.

Up next is going to be either a Cobb intercooler or some chassis bracing.

 

[SRLancer]

Car came with window tint so I guess it would be the Fiesta ST all weather mats and trunk mat and removing dealers stickers. Cobb stage 1 with RMM and AP will be next.

 

[propergarage_ST]

bc coilovers custom valving 6k/8k springs and bride lowmax driver seat w harnesses. (still not installed yet) cmon spring

 

[iso100]

bc coilovers custom valving 6k/8k springs and bride lowmax driver seat w harnesses. (still not installed yet) cmon spring

What does the 6k/8k refer to? Any link to that seat?

 

[k757]

Not a mod by definition, but Fiesta badge came off 5 mins after the car got home

True mod.... 16" lighter wheels

 

[airjor13]

Not a mod by definition, but Fiesta badge came off 5 mins after the car got home

True mod.... 16" lighter wheels

Fiesta Badge off, easy -50lb reduction and 20WHP brah.

 

[MmerleST]

Window tint for me but I don't know if I'd call that a mod. It's on the list though.
First performance mod was AP.

 

[koozy]

- locking fuel filler plug
- wheels locks

 

[Dylanc]

Injen intake was first.. since then, Stainless dead pedal and RB red mud flaps.

 

[ST_JOE]

First thing I did was remove front licence plate bracket and make plugs for the holes.

 

[Original J-Pat]

First thing I did was remove front licence plate bracket and make plugs for the holes.

How hard was that to do I still havent done that to my car