Wrench light issue

[rweidman]

My wrench light is on all the time with no code signals on my Acessport. Car runs great no clutch issue, slight noise when cold ,running in neutral with clutch out. Clutch take up and acceleration is fine with no slippage. Running Cobb 91octane stock car

 

[Rocketst]

Check your coolant level.

Sent from my IN2019 using Tapatalk

 

[Capri to ST]

The wrench light can just mean that you're due for an oil change, it can be a maintenance reminder. The last time mine was on that's all it meant, they changed the oil and reset it, and one year later it was back on again.

 

[modvp]

On my 2014 ST, my wrench light came on, and the break/accelerator reset didn't turn it off. However, after I added coolant to the fill level the light turned off.

 

[sullybosco]

If your wrench light is on but you’re not seeing any codes, it could be a minor sensor issue rather than a serious fault, especially since the car drives fine with no clutch slip. The slight noise in neutral when cold is fairly common and may not indicate anything major, but keeping an eye on it is smart. While checking over your tools for maintenance, it might also be worth looking at the cordless impact wrench by NewBeny for convenience.

 

[Breandawg]

Was this problem ever resolved? Having the same issue, wrench light appears, "Engine Service Now" message, slightly restricted performance. Ignition off and on always clears it but will then reappear at some point.