Confirm torque settings for all 3 motor mounts?

[mk_not_a_robot]

So I am planning on installing all 3 at the same time today / tomorrow.

I found the settings for all 3 here in the forums, but which settings are for which bolts / nuts are unclear for both driver / passenger sides.

So for the RMM I found:
50 ft/lbs for the large bolts on the rubber bushings
18 ft/lbs for the nuts found on the plate

Driver side:
3 nuts: 92 ft/lbs
1 bolt: 66 ft/lbs
??? pictures on the net show 3 bolt holes where it attaches to the tranny, and 2 that connect to the frame ... not so clear here either.
The picture was a after market one though, OEM might be different

Passenger side:
?? 59ft/lbs
?? 43 ft/lbs
There is the one big bolt into the connection between the 2 parts, but there are 2 bolt holes on the engine part, and 3 on the frame part ???


Could someone fill me in on which torque setting is for what on the driver / passenger sides?


I plan on putting grease on the passenger side "connector bolt" as well as on the bolts for the rubber bushing s on the RMM.
I'm also going to put loctite 451 (blue stuff) on all threads.


Thanks

 

[pirite]

Passenger side:
Middle Bolt 50 ft/lbs
Mount to Motor 59 ft/lbs
Mount to Body 35 ft/lbs

I looked them up at work when I did this write up
https://www.fiestastforum.com/threads/17204-ARP-Motor-Mount-Bolt-Install-from-Whoosh

 

[mk_not_a_robot]

Awesome, thanks dude!

I also caught this post by Koozy:


So only a small mystery remains, for the drivers side mount where it attaches to the frame.

 

[PunkST]

Question, do they need blue loctite? Im doing my passenger tomorrow. If so ill pick them up.

 

[rallyrabbit]

Rear:
Motor mount bolts 52 ft/lbs
Black Bracket to transmission 45 ft/lbs
Bracket to exhaust and studs on black bracket 25 ft/lbs

 

[TyphoonFiST]

https://www.fiestastforum.com/threads/vibratechnics-motor-mount-trans-mount-rmm-diy-install.22910/