How-To: Stock Height Rally Performance Springs for OEM/B6 style suspension

[Dialcaliper]

Here's a pic.

I'm a bit concerned by the front ride height. Seems like it might be getting lower. Left side may be slightly lower than the right. I wonder if the cheap springs I used in the front aren't very good.

The rear seems a bit higher than OEM. I'm tempted to cut a bit of height out...

Agreed, the rear looks close to factory “new” which if you look around online is the tire “centered” in the curve of both fenders. Your front is definitely low, but that just depends on personal preference of where you want it to sit

All springs will settle initially after a few hundred miles. Even my custom Bilstein setup built with entirely Swift springs settled between 1/2”-3/4” in the first month.

 

[Snrub]

I installed a set of these spring spacers in the front https://www.amazon.ca/gp/aw/d/B07WGF224D/ref=ox_sc_act_title_2?smid=A3BEBWTOARC1WU&psc=1

It definitely raised the front of the car back up about 1" which is where I'd like it to be. I think on smooth roads it rides better, I suspected it was sitting on the bumpstops before.

I'm not sure if the first spring loop at the bottom is considered a fully "active" spring. If it is, I assume I increased the spring rate by 20-25%. On rougher roads the ride feels harsher. I haven't had a chance to push it much in corners yet.

 

[Snrub]

I think I'm happy with the cheap spring spacers. I think i like the way the car handles now. Ideally, I'd like the ride to be a bit better, but it's about where it was when I had the Indy 500 tires on stock springs, as opposed the ECS 02 now.

I'm not sure my variation of dialcaliper's recipe with front springs from cheap aftermarket R56 rear springs, cut slightly, with spacers , is one I can confidently recommend to all, but this kludge solution seems to work. Part of me wonders if the springs I used are of OEM quality.