Turbo Tech Racing motor mounts - holy NVH!

[jeffreylyon]

I installed a set of Turbo Tech Racing motor mounts in my '16. What a difference - smoother starts, nicer shifts, *much* better tip-ins when leaving a corner, but the increased NVH is significant, so much so the whole dash vibrates around 1500. I'm hoping that they'll break in a little and I think I'll try lifting the engine just a tad with my hoist, loosening, and re-tighening everything as it seems possible that I've preloaded the mounts a little by doing one side at a time.

Has anyone out there experienced the same? Did they break in a bit?

Regarding the parts - good welds and machining but (really) crummy powder coat.

 

[A7xogg]

Well, I actually got rid of mine cause I thought they were too loud(but I also think my completely stock exhasut has drone) but they did break in but yeah like any full mount there loud. Also take a double check at the passenger mount, I think o had something slightly rubbing on mine cause the mount was not straight.

 

[alexrex20]

I can't comment on the mount itself because I don't have one, but adding a front upper strut brace REALLY helped reduce the increased dash rattle/creak in my car which was caused by the upgraded RMM.

 

[Plainrt]

Had just the pass side along with rmm at one point and it was horrible. Was told it was only bad because didn’t have drivers side solid mount.