I can't find the source of the ETC cut at 5,757 RPM for the life of me, looks to be torque related. Attached a file (looks like .txt is the way to attach, sorry) - 4th gear pull on E30... ETC Angle Source is 6 which is torque related.
Nice delta between TIP actual TIP Desired -- Modified all the "Limiter Table" > "Torque Limits" to raise values to no effect except for the "Torque Reduction Ratio" sections which remained OTS, didn't modify Max Load at WOT and Closed WG series, tried both with CCF Torque Features on/off with no effect, Load limits at 3.0 and most torque clipping is over 400FT-LB.
Any ideas?? Runs perfect other than losing ETC starting at 5,700RMP, same every time.
Nice delta between TIP actual TIP Desired -- Modified all the "Limiter Table" > "Torque Limits" to raise values to no effect except for the "Torque Reduction Ratio" sections which remained OTS, didn't modify Max Load at WOT and Closed WG series, tried both with CCF Torque Features on/off with no effect, Load limits at 3.0 and most torque clipping is over 400FT-LB.
Any ideas?? Runs perfect other than losing ETC starting at 5,700RMP, same every time.
Attachments
-
23.5 KB Views: 7
Last edited: