What did you do to your Fiesta ST today ?

Member ID
#3591
Messages
82
Likes
102
I replaced my front sway bar bushings just because it’s been 100k miles on the originals. The old ones actually looked pretty decent. Probably didn’t need to do it, but I had the parts. I also replaced my Mountune RMM with a new Vibratechnics unit I got from Whoosh. I was hoping for reduced NVH on fresh rubber vs 90k mile urethane, bit early impressions are not really any different. I plan to sell the Mountune RMM and the set of replacement bushings I bought last year but never used.
 


Intuit

4000 Post Club
Member ID
#4881
Messages
4,047
Likes
2,583
Bah. I got pulled over three times in one year for no front plate. (amongst the 99 other cars that didn't have one at all) It was either they get used to it or they changed the law. They eventually changed the law. 🤣
 


TyphoonFiST

9000 Post Club
Premium Account
Member ID
#3304
Messages
11,848
Likes
8,305
I really like that OEM Plus headlights. Where to buy headlights with projectors ready plug and plug ?
I got them made By Northern lighting when they were in business here on the Forum. i waited a bit but he did a good job! They were about 1k all said and done.
 


Member ID
#8891
Messages
322
Likes
172

SteveS

1000 Post Club
Member ID
#12296
Messages
1,535
Likes
1,832
The website is for the manufacturer of the kits. I'd suggest using the chat on the page to ask them about the Fiesta ST specifically. It looks like they can custom make any kind of wiring harness. And sell you the speakers and amps too.
 


akiraproject24

1000 Post Club
Member ID
#14293
Messages
1,141
Likes
1,280
The website is for the manufacturer of the kits. I'd suggest using the chat on the page to ask them about the Fiesta ST specifically. It looks like they can custom make any kind of wiring harness. And sell you the speakers and amps too.
I tried talking to this company a while back, tried to explain the fiesta st with a Sony non amplified 6 in display. The guy had no clue about it, assumed that if it was labeled Sony then it was the 8 in display. The conversation yielded me 0 answers
 


pixelzombie

Active member
Member ID
#12526
Messages
581
Likes
393
I was trying to replace the rear wiper blade, and the tabs that hold it in place snapped. Now I have to wrap it with a twist tie so it doesn't fall off. I'm assuming Rock Auto will have a replacement that is reasonably priced.
 


Member ID
#3114
Messages
283
Likes
411
How much torque and HP in those fire engines? They got more than one? How much they weigh? Borrow one from the "out of service" truck and stick it in your Fiesta? 😂
Not sure how much hp/tq they make, but they are inline 6 turbo diesels and weigh between 22 and 25 tons depending on the equipment they carry.
 




Top